|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
very good manual as always. easy to read, detailed and includes schematic
;
I'm very satisfied with your manual service. Your website made it easy to locate the correct manual. Also the quality is great and I never had a problem reading the fine details.
Thanks again.
Jeff Miller
JM Electronics
;
Good quality service manual German user manual. German user manual This is a quality scan of a manual in excellent condition and is just as good as having the original manual in hand
;
The manual for Sony LBT-D505 component stereo system is was excellent , with schematics, parts layout and parts list as well as instructions for adjustments for each component. Print was clear even when enlarged.
;
It's exactly a complete and very useful manual with all details what I needed. Thank you!I will come back whenever I need your manuals or schematics.
AV-21D81 AV-20N81 AV-16N81 AV-16N81G
DISASSEMBLY PROCEDURE
REMOVING THE REAR COVER
1. 2. 3. Unplug the power plug. As shown in figure, remove the
5 screws
marked
and the
2 screws marked
. Withdraw the rear cover toward you.
REMOVING THE PW BOARD
After removing the rear cover. 1. Slightly raise the both sides of the PW BOARD by hand. and remove the PWB stopper marked from the front cabinet. 2. Withdraw the PW BOARD backward. (If necessary, take off the wire clamp, connectors etc.)
REMOVING THE SPEAKER
After removing the rear cover. 1. As shown in figure, remove the 4 screws marked . 2. Follow the same steps when removing the other hand speaker.
CHECKING THE PW BOARD
1. To check the back side of the PW Board. 1) Pull out the PW Board. (Refer to REMOVING THE MAIN PW Board) 2) Erect the PW Board vertically so that you can easily check the back side of the PW Board. [CAUTION] When erecting the PW Board, be careful so that there will be no contacting with other PW Board. Before turning on power, make sure that the CRT earth wire and other connector are properly connected.
WIRE CLAMPING AND CABLE TYING
1. Be sure to clamp the wire. 2. Never remove the cable tie used for tying the wires together. Should it be inadvertently removed, be sure to tie the wires with a new cable tie.
12
No. 51902
|
|
|
> |
|