|
|
|
Who's Online
There currently are 5936 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good quality Service Manual, availability of components includes disassembly, electronic adjustments. Includes a full list of details and diagrams. Contains 58 pages.
 ;
y'm hapy for this shoping . Estoy feliz por esta compra , ahora puedo reparar mi equipo de audio que AMO . And very good price for this manual . Thank yuo .
;
Perfect manual, perfect service. Easy reading. Thanks a lot
;
Very good quality download here. Great hard to find manuals at a reasonable price.
;
I had a problem with the mains transformer, I did not know the voltages on the secondary, this manual helped me to solve this problem, thanks for the manual!
AV-29BF11ENS AV-29BF11EPS AV-29BF11EES
SPECIFIC SERVICE INSTRUCTIONS
DISASSEMBLY PROCEDURE
REMOVING THE REAR COVER
1. Remove the 8 screws marked A. 2. Remove the 4 screws marked B. 3. Withdraw the rear cover toward you.
CHECKING THE PW BOARD
To check the back side of the PW Board. 1) Pull out the PW Board. (Refer to REMOVING THE MAIN PWB). 2) Erect the PW Board vertically so that you can easily check the back side of the PW Board. [CAUTION] " When erecting the PW Board, be careful so that there will be no contacting with other PW Board. " Before turning on power, make sure that the wire connector is properly connected. " When conducting a check with power supplied, be sure to confirm that the CRT EARTH WIRE (BRAIDED ASS�Y) is connected to the CRT SOCKET PW board.
REMOVING THE MAIN PWB
" Removing the rear cover. 1. Slightly raise the both sides of the chassis by hand and withdraw MAIN PWB back ward. [CAUTIONS] If necessary, take off the wire clamp, connectors etc. Be careful enough when developing a main chassis.
REMOVING THE FRONT AV & HEADPHONE BOARD ASS�Y
" Removing the rear cover. " Removing the MAIN PWB. 1. Remove the 2 screws marked C, and remove the FRONT AV & HEADPHONE BOARD ASS�Y.
WIRE CLAMPING AND CABLE TYING
1. Be sure to clamp the wire. 2. Never remove the cable tie used for tying the wires together. Should it be inadvertently removed, be sure to tie the wires with a new cable tie.
REMOVING THE FRONT CONTROL PWB
" Removing the rear cover. " Removing the MAIN PWB. 1. Remove the 3 screws marked D, and remove the FRONT CONTROL PWB.
REMOVING THE WOOFER and TWEETER
" 1. 2. 3. Removing the rear cover. Remove the 4 screws marked E, and remove the WOOFER. Remove the 2 screws marked F, and remove the TWEETER. Remove an opposite side similarly.
REMOVING THE MAIN SWITCH
" Removing the rear cover. " Removeing MAIN PWB. 1. Remove the 2 screws marked G, and remove the MAIN SWITCH.
6
No.52084
|
|
|
> |
|
