|
Who's Online
There currently are 6036 guests and 7 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
This document is just what I was looking for, it´s very useful, it contains adjustment procedures for the final stage of the power amp and also
has a complete wiring diagram and description of the main semiconductors used in the design.
;
Dear Sirs,
Thank you for the fast support, the manual does provide all necessary information to repair the radio. All schematics are in a good quality for reading.
The manual fits 100% to my requirements as a technican.
Kind regards Thomas
;
the big video recorder format s-vhs many features delicate in loading system of the cassette. Such machines are no longer manufactured, it would be too expensive.
;
THIS MANUAL IS VERY GOOD AND VERY CLEAR
PLEASE NOTE IT DOES NOT CONTAIN THE SETUP INFORMATION TO ALIGHN THE GEARS IN THE CD MECH IT DOES SHOW ALL THE PARTS AND THEIR LOCATIONS .
;
Complete service and operation manual. All schematics are there, all circuit boards AND add-on boards. Including exploded views ,component names and specifications. Also electrical and mechanical adjustment procedures are in this manual. This manual also covers the more advanced BR-S811E unit. Scan quality is fair and usable.
AV-29BF11ENS AV-29BF11EPS AV-29BF11EES
SPECIFIC SERVICE INSTRUCTIONS
DISASSEMBLY PROCEDURE
REMOVING THE REAR COVER
1. Remove the 8 screws marked A. 2. Remove the 4 screws marked B. 3. Withdraw the rear cover toward you.
CHECKING THE PW BOARD
To check the back side of the PW Board. 1) Pull out the PW Board. (Refer to REMOVING THE MAIN PWB). 2) Erect the PW Board vertically so that you can easily check the back side of the PW Board. [CAUTION] " When erecting the PW Board, be careful so that there will be no contacting with other PW Board. " Before turning on power, make sure that the wire connector is properly connected. " When conducting a check with power supplied, be sure to confirm that the CRT EARTH WIRE (BRAIDED ASS�Y) is connected to the CRT SOCKET PW board.
REMOVING THE MAIN PWB
" Removing the rear cover. 1. Slightly raise the both sides of the chassis by hand and withdraw MAIN PWB back ward. [CAUTIONS] If necessary, take off the wire clamp, connectors etc. Be careful enough when developing a main chassis.
REMOVING THE FRONT AV & HEADPHONE BOARD ASS�Y
" Removing the rear cover. " Removing the MAIN PWB. 1. Remove the 2 screws marked C, and remove the FRONT AV & HEADPHONE BOARD ASS�Y.
WIRE CLAMPING AND CABLE TYING
1. Be sure to clamp the wire. 2. Never remove the cable tie used for tying the wires together. Should it be inadvertently removed, be sure to tie the wires with a new cable tie.
REMOVING THE FRONT CONTROL PWB
" Removing the rear cover. " Removing the MAIN PWB. 1. Remove the 3 screws marked D, and remove the FRONT CONTROL PWB.
REMOVING THE WOOFER and TWEETER
" 1. 2. 3. Removing the rear cover. Remove the 4 screws marked E, and remove the WOOFER. Remove the 2 screws marked F, and remove the TWEETER. Remove an opposite side similarly.
REMOVING THE MAIN SWITCH
" Removing the rear cover. " Removeing MAIN PWB. 1. Remove the 2 screws marked G, and remove the MAIN SWITCH.
6
No.52084
|
|
|
> |
|