The ease of this purchase was a good start. The content of this manual was exactly all I needed to retore my Tandberg 64.
All of the mechanical and electrical information is contained in the manual and the quality of the document makes reading the data easy.
The exerience with the resource has made this my prime source for technical data.
Owner-manuals.com is the best Possibility to give vantage HIGH CLASS Elektronic COMPONENTS
a new Life.Thanks alot for your perfekt Service.
Text excerpt from page 29 (click to view)
Item Adjustment of BOW
Measuring instrument Signal generator
Adjustment part 11.BOW
Description " In case where there is a bow-shaped distortion of images on the screen. 41. Select 11.BOW with the FUNCTION UP/DOWN key. 42. Adjust BOW, and bring the VERTICAL lines straight. 43. Press the MENU key and memorize the set value.
Remote control unit
Adjustment of V-S.CR & V.LINE
Signal generator Remote control unit
When the vertical linearity has been deteriorated remarkably, perform the following steps.
44. Receive a cross-hatch signal. 45. Select 13. V.LIN with the FUNCTION UP / DOWN key. 46. Set the initial setting value of 13. V.LIN with the FUNCTION - / + key. 47. Select 12. V-S.CR. with the FUNCTION UP / DOWN key. 48. Set the initial setting value of 12. V-S.CR. with the FUNCTION - / + key. 49. Adjust 13. V.LIN and 12. V-S.CR. to the spaces of each lines at TOP, CENTER, and BOTTOM become uniform.
NOTE : Do not adjust in â€śPANORAMICâ€ť and â€śSUBTITLEâ€ť mode.
At first the adjustment in 100Hz FULL mode should be done, then the data for the other aspect mode is corrected in the respective value at the same time. And confirm the deflection adjustment initial setting value in 120Hz (NTSC EXT mode) FULL mode. If the adjustment in 100Hz each aspect mode has been done and stored, the data for the same aspect modes in 120Hz is corrected in the respective value. Only the data for the other aspect mode in 120Hz is corrected for itself.