perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
Text excerpt from page 61 (click to view)
Recording time code following the one last recorded on the tape
BR-DV6000 is equipped with a time code reader. When it enters the RECORD mode from the RECORDING PAUSE mode, it reads the time code data already recorded on the tape and continues recording time code from that value. (Regeneration)
TC/UB/CLOCK(1/2) Menu screen
� � � TC / UB / C LOCK T CG SOURCE T CG SE L EC T T CG MOD E NDF / DF ( NTSC ) DF B I T ( PAL ) TC DUP L I CATE TC OFFSET NEXT PAGE PAGE BACK ( 1 / 2 )� � � I NTERNA L REGEN REC - RUN ��� ON OFF OFF
:Setting:
� Set the TC/UB/CLOCK(1/2) Menu as follows.
TCG SOURCE TCG SELECT TCG MODE : INTERNAL : REGEN : No setting required. It will be in the same run-
ning mode as the tape. NDF/DF (NTSC) : No setting is required. It will be in the same frame mode as the tape.
:Operation:
1. Insert a tape with time codes recorded. 2. Set BR-DV6000 to the RECORDING PAUSE mode at the position where time codes are to be recorded again.
3. Press the PLAY button to go to the RECORDING mode.
Â¥ Time codes will be recorded on the tape, starting from where it stopped at last recording. The counter mode display shows either TCR or UBR.
Recording time code, input to the DV IN/OUT terminal
TC/UB/CLOCK(1/2) Menu screen
� � � TC / UB / C LOCK T CG SOURCE T CG SE L EC T T CG MOD E NDF / DF ( NTSC ) DF B I T ( PAL ) TC DUP L I CATE TC OFFSET NEXT PAGE PAGE BACK ( 1 / 2 )� � � I NTERNA L PRESET REC - RUN ��� ON AUTO OFF
:Setting:
Set the INPUT SELECT switch on the front panel to DV. Set TC DUPLICATE in the TC/UB/CLOCK(1/2) Menu screen to AUTO.
* To record time codes in the NON DROP frame mode from BRDV600 or GY-DV500, set TC DUPLICATE to NON DROP.
Memo
Time codes input to the TIME CODE IN terminal are ignored. Do not connect any device to the TIME CODE OUT terminal.
:Operation:
1. Check the time code of the DV input terminal.
Press the REC button when BR-DV6000 is in the STOP mode to display the time code on the monitor or the LCD. It will be displayed while the button is held down. The counter mode display shows DTCG or DUBG. 2. Select the RECORDING mode. ¥ Record time codes from the DV input terminal.
Memo
� For date/time also, data from the DV IN terminal are recorded. � When this terminal is connected to a D9 VCR, data/time data are not recorded.
