There are currently no product reviews.
I've been looking for a copy of the original user/owner manual. Just what the doctor ordered, thank you.
the manual was very helpful thank you very much no one else was able to help me thanx
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Creating Your Own Sound Mode â€” Manual Mode
You can change SEA pattern to suit your preference. These changed settings can be stored in the MANUAL 1, MANUAL 2, and MANUAL 3 modes. â€¢ There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
4 Press SET/DISPLAY again.
On the unit ONLY:
5 Turn 4 / Â¢ to select one of
the MANUAL 1, MANUAL 2, and MANUAL 3 modes into which you want to store the SEA pattern.
1 Select one of the preset sound modes.
â€¢ If you want to add the surround elements in your SEA pattern, select one of the surround modes (D.CLUB, HALL, or STADIUM) before starting the procedure below. (See â€śSelecting the Sound Modesâ€ť on page 10.)
6 Press SET/DISPLAY again.
2 Press and hold SET/DISPLAY
until â€śSEA CONTâ€ť appears on the display.
The SEA pattern you have created are stored into the MANUAL mode selected in the above step.
To use your own sound mode
Select MANUAL 1, MANUAL 2, or MANUAL 3 mode when using the sound modes. See â€śSelecting the Sound Modesâ€ť on page 10.
Current level appears.
When you unplug the AC power cord or if a power failure occurs The setting will be erased in a few days. If this happens, set the manual sound modes again.
3 Adjust the SEA pattern.
1) Turn 4 / Â¢ to select the frequency range to adjust (LOW, MID, HIGH). 2) Press 1 or Â¡ to adjust the level (â€“3 to +3) of the selected frequency range. 3) Repeat steps 1) and 2) to adjust the level of the other frequency ranges.
â€“ 11 â€“