perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Super nice! Good to have a manual in digital format.
Text excerpt from page 14 (click to view)
English
AM (MW/LW) antenna
Connecting Speakers
You can connect a pair of the front speakers.
1
2
3
1
Vinyl-covered wire (not supplied)
ANTENNA
FM 75
COAXIAL
2
3
CAUTION: SPEAKER IMPEDANCE 6~16 OHMS.
Red Speaker cord
SPEAKERS
AM EXT AM LOOP
Speaker cord
GND
RIGHT
LEFT
Black
AM (MW/LW) loop antenna (supplied)
1 Connect the AM (MW/LW) loop antenna to
the AM LOOP terminals as illustrated.
Right speaker
Left speaker
2 Turn the AM (MW/LW) loop antenna until
you have the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM (MW/LW) loop antenna must remain connected.)
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to red (+) and black (�) to black (�).
For better reception of both FM and AM (MW/LW) � Make sure the antenna conductors do not touch any other terminals and connecting cords. � Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.
3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.