|
Who's Online
There currently are 5851 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
34 EN
INITIAL SETTINGS (cont.) NOTES:
� The Controller may not work with all types of DBS receiver. � If your DBS receiver does not respond to the code, you cannot use the Controller to change satellite channels. In this case, make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording. � The unit can only change the satellite channel through the Controller during timer recording. � If your DBS receiver cannot be operated with a Remote (because it has no remote sensor), you cannot use the Controller to change its channels. Make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording. � If the unit�s memory backup expires because of a power failure, set the cable box output channel and brand again. � For customers in U.S.A.: If you are unable to set the Controller, contact JVC toll free at 1-800-252-5722.
E
Enter the DBS receiver�s brand.
A Press rt to move the arrow to �DBS RECEIVER BRAND�, then press ENTER. B Press rt to select the brand code from the following list, then press ENTER. C Press rt to move the arrow to �TEST MODE�, then press ENTER. The program currently received through the DBS receiver appears.
BRAND NAME JVC (DISH Network) ECHOSTAR (DISH Network) SONY (DSS) RCA (DSS) CODE 51 51 41 40
If the DBS receiver�s channel changes to the channel listed below for your brand, setting is complete. JVC ] 100 ECHOSTAR ] 100 SONY ] 205 RCA ] 205 Press ENTER and �DBS RECEIVER CONTROL IS ON� appears on the screen for about 5 seconds, then press ENTER.The screen in step C appears. If the DBS receiver�s channel does not change as shown above; A Press w e to move the arrow to �NO�, then press ENTER. B Repeat step E.
$4.99 DRM10SUC JVC Service Manual Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…
|
|
|
> |
|