There are currently no product reviews.
It is perfect, exactly what we needed. It's like the paper version but less clutter.
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Immediate response with excellent service - highly reccommended
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Listening to FM and AM Broadcasts
Tuning In a Station
1 When the unit is turned on, press TUNER/BAND to select tuner mode.
The unit tunes in the last station tuned in (either FM or AM).
You can preset 20 FM and 20 AM stations.
â¢ There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
1 Tune in the station you want to preset.
2 Press TUNER/BAND to select the band, FM or AM.
Each time you press the button, the band selection alternates between FM and AM.
â¢ See âTuning In a Stationâ on the left.
2 Press PROGRAM.
The PROGRAM indicator and â00â start blinking on the display.
3 Press and hold 4 or Â¢ for more than 1 second.
The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in. If a program is broadcast in stereo, the STEREO indicator lights up. To stop searching, press 4 or Â¢.
3 Press PRESET â or 5 (or REPEAT/PRE DOWN or PRE UP on the remote control) to specify the desired preset number.
4 Wait a few seconds to confirm the preset number.
â¢ Alternatively, press PROGRAM.
When you press 4 or Â¢ briefly and repeatedly
The frequency changes step by step.
5 To preset more stations, repeat the steps above, allocating a different preset number to each station.
When a new station is stored The station previously memorized with the same preset number is erased. (The frequency of the new station replaces the previous frequency in memory.)
Tuning In a Preset Station
1 Press TUNER/BAND to select tuner mode.
2 Press TUNER/BAND to select the band, FM or AM. 3 Press PRESET â or 5 (or REPEAT/PRE DOWN or PRE UP on the remote control) to select the desired preset number.
â 10 â
Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…