|
Who's Online
There currently are 5518 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Recording
IMPORTANT:
� It may be unlawful to record or playback copyrighted material without the consent of the copyright owner. � The recording level is automatically set correctly, so it is not affected by the volume control. Thus, during recording you can adjust the sound you are actually listening to � without affecting the recording level. While recording, you can hear sound modes and/or the HBS sound effect through the speakers. However, the sound is recorded without these effects (see page 9). If recordings you have made have excessive noise or static, the unit may be too close to a TV. Increase the distance between the TV and the unit. Use only type I normal tapes for recording. The use of tapes longer than 120 minutes is not recommended, since characteristic deterioration may occur and these tapes easily jam in the pinch roller and the capstan.
Recording Tapes
1 Load a recordable tape into the tape deck. 2 Press TAPE/REV.MODE repeatedly to either record one side or both sides of the tape.
: recording on one side only : recording on both sides � When you select , make sure that there is no content that should not be lost is recorded on either side of the tape.
REV. MODE
TAPE
�
� �
3 Press CD/RANDOM or TUNER/BAND to select the desired recording source. 4 Prepare the source.
RANDOM
BAND
CD
or
TUNER
To protect your recording
Cassettes have two small tabs on the back to prevent unexpected erasure or re-recording. To protect your recording, remove these tabs. To re-record on a protected tape, cover the holes with adhesive tape.
� For synchronous recording of a CD Load the disc (see page 11). � To start recording from the desired track, select the track by pressing 4 or ¢ repeatedly in stop mode. � To start recording from the desired point on a disc, play the disc and pause at the desired point by pressing 3/8. � For recording from the radio Tune in the desired station (see page 10).
5 Press REC.
�REC� is displayed. The TAPE REC indicator and �8� light up and the recording direction indicator starts blinking.
REC
6 While the recording direction indicator is blinking, press 8/2 or 3/8 to select the recording direction.
PRESET DIRECTION PLAY/PAUSE
Recording starts. �8� goes off. The TAPE REC indicator remains on the display. When recording a CD, the CD SYNC indicator also lights up. To stop recording, press 7. The selected recording source continues playing. � During recording, it is not possible to pause or listen to another source. �REC ON� appears on the display. � Recording continues to the end of the tape until you press 7 even after playback of the CD has finished.
Using the BEAT CUT function
When recording an AM broadcast, beats may occur. If this happens, press BEAT CUT on the remote control to select the better beat-cut position, �BEAT 01� or �BEAT 02�.
� 14 �
English
$4.99 FSM5 JVC Service Manual Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…
|
|
|
> |
|