|
Who's Online
There currently are 5827 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The AKAI 1720 model reel to reel tape recorder described in this Manual is quite an old unit - circa late 1960's. As a consequence, the description of the mechanical details - and adjustments thereof - is quite critical. The manual does this quite well. The schematics are also well presented and have detailed PCB overlays. Probably the only negative is that some half-tone detail has been lost from the original manual as it has been scanned in simple B&W.
;
Perfect source for service manuals: fast and professional transaction; high quality, perfect readable and largely scaleable PDF; complete schemes, diagrams and spare part list. Tnx a lot, cu again!!!!
;
I got your link from a friend and I must say that I am really satisfied with your service. Specially this B&O manual I didn't find anywhere on the web... but you could deliver it :-) . You deliver very fast and the copy is of good quality. So your webpage is bookmarked. Thanks
;
This was the Sony CCU-500A Service manual I was looking for.
The price was reasonable.
The permission to download was quck.
I will use Owner-Manual.com for all my manual needs.
;
Excellent printing quality.
A complete and very usefull service manual with all details.
GREAT SERVICE AT VERY LOW PRICE!
A+++++++++++++++++++++++++
FS-SD5/FS-SD7/FS-SD9 <CD mechanism base assembly>
Prior to performing the following procedure, remove the CD mechanism base assembly. Refer to "Dismantling and assembling the CD mechanism assembly" on page 1-5 for the treatment of optical pickup.
CD mechanism cover CD mechanism board
U
CN706
Speaker terminal board
T U
Removing the speaker terminal board (See Fig.28)
1. Remove the two screws T attaching the speaker terminal board on the underside of the CD mechanism base assembly.
CN703
U
CD mechanism assembly
Fig.28
U
Removing the CD mechanism board / CD mechanism assembly (See Fig.28 to 32)
1. Turn over the CD mechanism base assembly and disconnect the harness from connector CN703 and CN706 on the CD mechanism board. 2. Turn over the CD mechanism base assembly and disconnect the harness from connector CN703 and CN706 on the CD mechanism board. 3. Turn back the CD mechanism assembly and detach the CD mechanism cover while pulling the CD mechanism assembly outward to release the two joint tabs marked c. 4. Disconnect the card wire from the connector of the CD mechanism assembly inside the CD mechanism cover. Disconnect the harness from CN605 on the CD mechanism board. Pull the CD mechanism assembly out of the three shaft of the CD mechanism cover. ATTENTION: When reassembling, confirm that the cushion of the CD mechanism assembly is reattached to the three shafts. 5. Remove the CD mechanism board from the CD mechanism cover.
Cushion CD mechanism assembly Cushion CD mechanism cover
Joint c
Tab
CD mechanism cover
Fig.29
CD mechanism assembly
CD mechanism cover Tab
Joint c
Fig.30
Shafts
CD mechanism cover
CN605 CD mechanism board
Short circuit land
CD mechanism board
Fig.31
Fig.32
1-13
|
|
|
> |
|