|
Who's Online
There currently are 5718 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Excellent service from Owner-Manuals.com, good prices and quick turn around. The supplied PDF was good enough quality to be enlarged sufficiently to read component values.
;
Very complete shop manual. It contains everything needed to troubleshoot bascially any problem. Instructions, diagrams, schmeatics, illustrations... it's all there. Highly recommended!
;
Great product, very good quality, found all needed information. Thanks
;
Excellent quality, helped to fix problem. Thank you very much!!!!
;
I thank Owner-Manuals.com for providing the necessary manual very quickly, and it was very helpful in repairing my personal Audio System and I once again thank them for the wonderful customer's service satisfaction.
Thanks.
FS-SD5/FS-SD7/FS-SD9 <CD mechanism base assembly>
Prior to performing the following procedure, remove the CD mechanism base assembly. Refer to "Dismantling and assembling the CD mechanism assembly" on page 1-5 for the treatment of optical pickup.
CD mechanism cover CD mechanism board
U
CN706
Speaker terminal board
T U
Removing the speaker terminal board (See Fig.28)
1. Remove the two screws T attaching the speaker terminal board on the underside of the CD mechanism base assembly.
CN703
U
CD mechanism assembly
Fig.28
U
Removing the CD mechanism board / CD mechanism assembly (See Fig.28 to 32)
1. Turn over the CD mechanism base assembly and disconnect the harness from connector CN703 and CN706 on the CD mechanism board. 2. Turn over the CD mechanism base assembly and disconnect the harness from connector CN703 and CN706 on the CD mechanism board. 3. Turn back the CD mechanism assembly and detach the CD mechanism cover while pulling the CD mechanism assembly outward to release the two joint tabs marked c. 4. Disconnect the card wire from the connector of the CD mechanism assembly inside the CD mechanism cover. Disconnect the harness from CN605 on the CD mechanism board. Pull the CD mechanism assembly out of the three shaft of the CD mechanism cover. ATTENTION: When reassembling, confirm that the cushion of the CD mechanism assembly is reattached to the three shafts. 5. Remove the CD mechanism board from the CD mechanism cover.
Cushion CD mechanism assembly Cushion CD mechanism cover
Joint c
Tab
CD mechanism cover
Fig.29
CD mechanism assembly
CD mechanism cover Tab
Joint c
Fig.30
Shafts
CD mechanism cover
CN605 CD mechanism board
Short circuit land
CD mechanism board
Fig.31
Fig.32
1-13
|
|
|
> |
|