just what i was seeking .had a password issue but the review allowed me to circumvent and download was great
Text excerpt from page 13 (click to view)
6. Pull out the CD mechanism assembly from the three shafts of the CD mechanism cover in the direction of the arrow. ATTENTION: When reassembling, confirm that the cushion of the CD mechanism assembly is reattached to the three shafts. 7. Remove the CD mechanism board from the CD mechanism cover. CAUTION: When reassembling, unsolder the short circuit round after connecting the flexible wire to the connector.
CD mechanism board Shafts CD mechanism cover
Removing the jack board (See Fig.40)
Prior to performing following procedure, remove the CD mechanism board. 1. Disconnect the wire from connector CN502 on the jack board. 2. Remove the two screws W attaching the jack board.
CD mechanism board CN706
Removing the switch board (See Fig.41)
Prior to performing following procedure, remove the CD mechanism board. 1. Disconnect the wire from connector CN502 on the jack board. 2. Remove the six screws X board. attaching the switch
Removing the LED board (See Fig.41 and 42)
1. Disconnect the harness from connector CN706 on the CD mechanism board on the underside of the CD mechanism base assembly. 2. Push inward the two tabs d attaching the LED board case and release them. 3. Pull out the LED board from the LED board case.