|
Who's Online
There currently are 5860 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
;
Great copy of the manual, has all information required for servicing,
3.1.8 Removing the digital amplifier board (See Fig.11) � Prior to performing the following procedures, remove the rear cover, bottom case (A), bottom case (B) and top case assembly. (1) From the left side of the main body, disconnect the wire from the connector CN301 on the digital amplifier board. (2) Remove the spacer and tie band fixing the wire. (3) Remove the two screws K, two screws L and screw L' attaching the digital amplifier board. (4) Pull the digital amplifier board toward this side, disconnect the connectors CN961 and CN981 on the digital amplifier board. Reference : � When attaching the screw L', attach the earth wire together it. � After connecting the wire, fix the wire with the spacer and tie band.
Digital amplifier board
Tie band
K
CN981 CN961 Spacer
K
Wire
Earth Wire
CN301
L
L'
Fig.11
L
3.1.9 Removing the power supply board (See Figs.12 to 14) � Prior to performing the following procedures, remove the rear cover, bottom case (A), bottom case (B), top case assembly, tuner, function board, micon board and digital amplifier board. (1) From the top side of the main body, remove the two screws M attaching the center chassis. (See Fig.12.) (2) From the bottom side of the main body, remove the two screws N attaching the power supply board. (See Fig.13.) (3) Disconnect the card wire from the connector CN903 on the power supply board. (See Fig.14.) (4) Remove the three screws P attaching the power supply board. (See Fig.14.) (5) Remove the barrier (E) and barrier (F) under the power supply board. (See Fig.14.) Reference : � Before attaching the each parts, pass the card wire through the holes f on the center chassis. � After attaching the center chassis, put the earth wire through the slit g of the power supply board and sections h of the center chassis.
N
Power supply board
N
Fig.13
Bottom chassis
Card wire
Hole f
Center chassis
P
Power supply board Card wire
M M P
Bottom chassis Earth wire Slit g
Fig.12
Section h
Barrier (E) Barrier (F)
P
Fig.14
CN903
1-12 (No.MB004)
$4.99 FS-X1 JVC Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft… $4.99 FS-X1 JVC Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
|
|
> |
|