There are currently no product reviews.
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
Copy of genuine owners/operators manual, very useful
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
Using the Timers
Press the SET button.
The minute digits of the time indication blink on the display. â¢ To return to the hour setting, press the CANCEL button.
Press the 3 or 2 button to set the minute. Press the SET button.
âADJUST OK!â appears on the display. The Clock indicator ( ) remains lit. Then, the selected time is set and the seconds start counting from 0.
â¢ If there is a power failure, the clock loses its setting. â0:00â and the Clock indicator ( ) blinks on the display and the clock must be reset.
Display the source (clock is canceled)
Showing the Clock (DISPLAY)
You can show the current time on the display. To display the clock, press the DISPLAY button on the Remote Control. To return to the normal display, press the same button again.
Perform steps 2 to 5 in âSetting the Clockâ on page 22-23.
Correcting the Clock
Use the following method to correct any clock shift. â You can correct the clock whether the System is turned on or off.
â¢ When the System is in power saving mode, nothing appears on the display. To see the clock, press the DIMMER button on the Remote Control. â¢ The clock may gain or lose one to two minutes per month. â¢ If there is a power failure, the clock loses its setting, â0:00â blinks on the display and the clock must be reset. To reset the clock, see âSetting the Clockâ on page 22-23.
Setting the Daily Timer
Once you have set the Daily Timer, the timer will be activated at the same time every day. The âDAILYâ indicator on the display shows that the Daily Timer you have set is in effect. You can set the Daily Timer whether the System is on or off (but not in power saving mode (See page 11)).
Repeatedly press the CLOCK/TIMER button to show the clock on the display.
Each time you press the button, the display changes as follows.
â¢ If you have made a mistake while setting the timer, press the CANCEL button on the Remote Control. However, this does not always cancel the current setting. If the CANCEL button does not work, press the CLOCK/TIMER button on the Remote Control repeatedly until the display returns to the original display, and start from the first step.