Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
Text excerpt from page 12 (click to view)
12 EN
GETTING STARTED
How To Attach The Lens Cap
To protect the lens, attach the provided lens cap to the camcorder as shown in the illustration.
Power
This camcorder�s 2-way power supply system lets you choose the most appropriate source of power. Do not use provided power supply units with other equipment.
NOTE:
To confirm the lens cap is on correctly make sure the cap is flush to the camcorder.
Charging The Battery Pack
Battery pack mount
Battery pack
PUSH BATT.
Place here during shooting.
How To Attach The Shoulder Strap
Follow the illustration.
Arrow
POWER/ CHARGE lamp
1 Thread the strap through the eyelet. 2 Fold it back and thread it through the strap
guide and the buckle.
� To adjust the length of the strap, loosen and then tighten the strap in the buckle.
To DC connector
To AC outlet Power switch
3 Slide the strap guide fully towards the eyelet.
Buckle Strap guide AC Adapter (ex. AP-V17E)
2 2
1 Set the Power Switch to �OFF�. 2 With the arrow on the battery pack pointing 3 Slide down the battery pack until it locks in
place b.
downward, push the battery pack slightly against the battery pack mount a.
4 Connect the AC Adapter to the camcorder. 5 Connect the Power Cord to the AC Adapter.
(AP-V14E only)
1
Eyelet
3
6 Plug the AC Adapter into an AC outlet. The
POWER/CHARGE lamp on the camcorder blinks to indicate charging has started. 7 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.
