|
Who's Online
There currently are 5864 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very quick and easy website to use and fast download of manual, quality of manual is excellent and will be pleased to use this service again in the future, thanks so much!
;
It is an very good and clear scanned service manual.
very recommended.
;
Easy to order the manual. Good quality and fast delivery.
;
The Service Manual for Sansui AU-9500 was very helpfull, in complete and in good printable condition.
Thanks.
;
Dear Sir,
Document is original service document of sharp. I had a problem with the door contacts. Fuses where blown. With the manual in a few minuts is was clear what the problem was.
Manual was of great help.
With kind regards,
Martie Verhoeven
The Netherlands.
3.4 MECHANISM COMPATIBILITY ADJUSTMENT 3.4.1 Tape pattern check (1) Connect the JIG CONNECTOR CABLE to the set. As for the connection procedure, JIG CONNECTOR BOARD and see 3.5 ELECTRICAL ADJUSTMENT. (2) Remove the COVER(ADJUST) (3) Play back the compatibility adjustment tape. (4) While triggering the HID1, observe the waveform of ENV_OUT. (5) Confirm that the waveform is free from remarkable leveldown, and entirely parallel and straight. (6) In case any level-down is observed on the left hand side, straighten the level by turning the GUIDE ROLLER (SUP) of the POLE BASE ASSEMBLY. In case any level-down is observed on the right hand side, however, straighten the level by turning the GUIDE ROLLER(TU) of the POLE BASE ASSEMBLY. (7) After adjustment, try the unloading motion once, and confirm that the waveform is flat (straight) when the tape has been played back again. Moreover, perform readjustment as required. (8) When the recording has been played back again, play back the self-recording to confirm that the waveform is flat.
ENV_OUT
HID1
Fig.3-4-1
Flatten the waveform. Misalignment of guide roller height on the supply side Misalignment of guide roller height on the take-up side
Fig.3-4-2
GUIDE ROLLER (SUP)
GUIDE ROLLER (TU)
COVER (ADJUST) JIG CONNECTOR CABLE
Refer To 3.3
JIG CONNECTOR
TO JLIP_RX RED TO JLIP_TX WHITE TO GND BLACK
COMMUNICATION CABLE
JIG CONNECTOR
OSCILLOSCOPE
TO ENV_OUT TO HID1
Fig.3-4-3
(No.86730)1-21
$4.99 GR-D40EX JVC Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|