|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Good quality service manual German user manual. German user manual This is a quality scan of a manual in excellent condition and is just as good as having the original manual in hand
;
The manual for Sony LBT-D505 component stereo system is was excellent , with schematics, parts layout and parts list as well as instructions for adjustments for each component. Print was clear even when enlarged.
;
It's exactly a complete and very useful manual with all details what I needed. Thank you!I will come back whenever I need your manuals or schematics.
;
I searched EVERYWHERE looking for the manual/s on this "extinct" amp. Owner-Manuals.com made it available and for nearly nothing. Thanx to them, I can decipher the unknown cables and sort them out. Thanx, Owner-Manuals.com!!
;
Yes thank you i got the file i was after. There was a slight problem in my communication but it all worked out well.
A job well done.
2.6.2 Adjustment of the Tension Arm and Pad Arm Assemblies Use Fig. 2-6-2 as the reference unless otherwise specified. 1. Set the PLAY mode. Se Fig. 2-3-8. 2. Loosen the screw A . 3. With the take-up side at the bottom, align the extreme end of the Tension Arm Assembly with the crossed grooves on the screw B that retains the Loading Motor Assembly and then tighten the screw A . The tightening torque should be 0.069 N�m (0.7 kgf�cm). 4. Check the operation. Repeat unloading and loading several times and make sure that the Tension Arm Assembly is located within the normal range. Note : With the above checking method, a Torque Meter is not used. When a Torque meter is used, the following are the reference values: Back Tension : 2.0 to 6.0 g�cm Play Torque : 8.3 to 12.5 g�cm
SCREW B TENSIOM ARM ASSY
2, 3 SCREW A
Fig. 2-6-2
2.6.3 Adjustment of the Slide Lever 2 Use Fig. 2-6-3 as the reference unless otherwise specified. 1. Set the C IN mode. See Fig. 2-3-4. 2. Loosen the screw A . 3. Set the Main Deck and Slide Deck Assemblies apart so that they do not rattle, then tighten the screw A by screwing it fully toward the Drum Assembly. The tightening torque should be 0.069 N�m (0.7 kgf�cm). 4. Check the operation. Repeat unloading and loading several times and make sure that these operations can be performed smoothly without producing rattles.
3
2, 3 SCREW A
3
Fig. 2-6-3
2-16
|
|
|
> |
|