JVC GRDV2000ED
Owner's Manual

EN57
Power Switch

Dubbing From A VCR
[To use this camcorder as a recorder]

1
To AV To S-VIDEO

Make sure all units are turned off, then connect the camcorder and the VCR as shown in the illustration. Also refer to pg. 52 and 53. Set �SOUND MODE� to �12 BIT� or �16 BIT� and �REC MODE� to �SP� or �LP� in the Menu Screen depending on your preference ( pg. 39). Set the camcorder�s Power Switch to � � while pressing down the Lock Button located on the switch. Turn on the VCR�s power and insert the appropriate cassettes in the camcorder and the VCR.

2 3 4 5

Connector cover**

Set �S/AV INPUT� to �ON� in the Menu Screen to engage the analogue input mode ( pg. 39). Press the Recording Start/Stop Button on the camcorder to engage the Record-Pause mode. � AV. IN � appears on the screen. Engage the VCR�s Play mode, then engage the Still Playback mode when you have found a spot just before the edit-in point. Press the Recording Start/Stop Button on the camcorder to engage the Record mode. rotates on the screen. Engage the VCR�s Play mode. To stop dubbing, press the Recording Star/Stop Button on the camcorder so that stops rotating, then engage the VCR�s Stop mode. Repeat steps 6 through 8 for additional editing. Set �S/AV INPUT� back to �OFF� in the Menu Screen to disengage the analogue input mode ( pg. 39).

S-Video cable (provided)

Audio/Video cable [mini-plug to RCA plug] (provided)

6 7
To AUDIO, VIDEO* and S-VIDEO OUT connectors

8 9 10

VCR (Playback deck)

TV

* Connect when an S-Video cable is not used. ** When connecting the cables, open this cover.

NOTES: � It is recommended to use the AC Power Adapter/ Charger as the power supply instead of the battery pack ( pg. 7). � Analogue signals can be converted to digital signals with this procedure. � It is also possible to dub from another camcorder.