|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent manual. In addition to the information I needed was a complete description of both electronic and mechanical devices.
Excellent site.
Thank you very much.
 ;
very good and complete manual , it is in english and german is perfect for repair.
;
This manual is complete and of high quality. I am very pleased with the purchase.
;
Another excellent buy! A fully readable PDF archive. Good prints!!
;
It is wonderful done!!! a great job in scanning the manual. Superior quality in all the electric scheme. Very understandable and net!!! Thank you!
1.7 MANUAL EJECTION OF THE CASSETTE TAPE Note: The following procedure describes a simplified method of ejecting the cassette tape in case it is not possible to eject it, due to an electrical failure. Be careful not to damage any of the parts or the tape 4. In order to change the mechanism mode at the unloading end apply 3 V, DC to the electrode on the top surface of the Loading Motor Assembly and then set it to the eject mode. 5. If there is any slack tape in the tape transport system, wind it inside the cassette tape by turning the Supply Reel Disk from the backside of the Slide Deck Assembly. 6. Peel off the PVC tape and take out the cassette tape from the cassette housing. Note: Make sure that grease or a similar substance is not attached to the surface of the tape. Similarly, also make sure that grease or a similar substance is not attached on the Mechanism Assembly.
when performing repairs or maintenance work.
1. Remove the Power Unit (battery, DC code, etc.) from the main unit. 2. Open the cassette cover. 3. Attach a piece of PVC tape at the front of the cassette housing. Note: This helps prevent the tape from being damaged when the Cassette Housing Assembly is moved upward at the unloading end.
(DC3V)
REEL DISK ASSY (SUP) PVC TAPE
Fig. 1-7-1
1-10
|
|
|
> |
|
