JVC GR-DVJ70EK
Owner's Manual

20

EN

RECORDING (Cont.)
5S 5SD ANIM.

SCENE BEEP W IND CUT SOUND MODE I D No .

5S
ON OFF

48kHz 07

ON OFF OFF AUTO 48 kHz 32 kHz

END

I TEM ZOOM SW . SET SET BUTTON
This number will be necessary in the future when connecting the camcorder to a computer [01 to 99].

Sound
Sound signals can be sampled at 48 kHz or 32 kHz. 48 kHz�The camcorder is factory-preset for 48 kHz. This setting enables recording of stereo sound on two separate channels. *A tape recorded at 48 kHz cannot be used for Audio Dubbing. 32 kHz�This setting enables recording of stereo sound on four separate channels, and is recommended for use when performing Audio Dubbing.

Beep
The beep sounds when the power is turned on or off, and at the beginning and end of recording. ON�To activate the beep. OFF�To turn off the beep.

NOTE:
Beep is automatically turned on during Full Auto operation.

Wind Cut
When activated, this mode helps cut down on noise created by wind. AUTO�When shooting in high winds, noise is automatically reduced. �� � appears in the viewfinder. �The quality of the sound will change. This is normal. OFF�This function is disabled.

Scene (5-Second Mode)
This mode is enabled when the Power Dial is set to �5S�. 5S�Pressing RECORDING START/STOP allows you to take a 5-second �clip�. Press repeatedly for a succession of short recordings. 5SD�If you record a 5-second clip within 5 minutes after the previous one, the end of the old scene dissolves and is replaced by the new scene over a 2-second period ( pg. 25). ANIM. (Animation)�Each time you press RECORDING START/STOP, a 1/8-second recording is taken. By using an inanimate object and changing its position between shots, you can record the subject as though it�s moving.

NOTE:
The Wind Cut mode is disabled during Full Auto operation.