Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Text excerpt from page 10 (click to view)
Power Zoom Lever
GETTING STARTED (cont.)
Recording Start/Stop button
1 Separate the Velcro strip. 2 Pass your right hand through the loop and grasp the grip. 3 Adjust your thumb and fingers through the grip, to
easily operate the Recording Start/Stop button and Power Switch and Power Zoom Lever. Be sure to fasten the Velcro strip to your preference.
Dioptre Adjustment Control
1 Set the Power Switch to â AUTO â or â MANUAL â
while pressing down the Lock Button located on the switch.
2 Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
Shoulder Strap Attachment
1 Make sure the battery pack is removed. Following
2 1 3
the illustration, thread the strap through the eyelet 1, 2. then fold it back and thread it through the buckle Repeat the procedure to attach the other end of the strap to the other eyelet 3 located under the Grip Strap . Confirm the strap is not twisted.
When attaching the camcorder to a tripod, extend its legs to stabilise the camcorder. It is not advised to use small sized tripods. This may cause damage to the unit by falling over.
1 To attach the camcorder to a tripod, align the
direction stud and screw to the mounting socket and stud hole on the camcorder. Then tighten the screw clockwise. Some tripods are not equipped with studs.