perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Super nice! Good to have a manual in digital format.
Text excerpt from page 11 (click to view)
Power Zoom Lever
GETTING STARTED (cont.)
1 Separate the Velcro strip. 2 Pass your right hand through the loop and grasp
Recording Start/Stop button
3 Adjust your thumb and fingers through the grip, to
easily operate the Recording Start/Stop button and Power Switch and Power Zoom Lever. Be sure to fasten the Velcro strip to your preference.
Dioptre Adjustment Control
1 Set the Power Switch to â AUTO â or â MANUAL â
while pressing down the Lock Button located on the switch.
2 Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
Shoulder Strap Attachment
1 Make sure the battery pack is removed. Following
2 1 3 Tripod Mounting
When attaching the camcorder to a tripod, extend its legs to stabilise the camcorder. It is not advised to use small sized tripods. This may cause damage to the unit by falling over. the illustration, thread the strap through the eyelet 1, 2. then fold it back and thread it through the buckle Repeat the procedure to attach the other end of the strap to the other eyelet 3 located under the Grip Strap. Confirm the strap is not twisted.
1 To attach the camcorder to a tripod, align the
direction stud and screw to the mounting socket and stud hole on the camcorder. Then tighten the screw clockwise. Some tripods are not equipped with studs.