There are currently no product reviews.
Super nice! Good to have a manual in digital format.
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Set the Power Dial to â A â while pressing down the lock button located on the dial.
SELECT OPERATION MODE
PULL OUT VIEWFINDER OR OPEN LCD MONITOR
Pull out the viewfinder fully or open the LCD monitor to approx. 90 degrees. â¢The lens cover opens, the power lamp comes on and the scene youâre aimed at appears. â¢The Record-Standby mode is engaged.
When âPAUSEâ appears, press START/STOP. A beep signals the start of recording and the tally lamp comes on.
â The image will not appear simultaneously in the LCD monitor and the viewfinder. No image appears on the LCD monitor when the viewfinder is pulled out. It is not possible to shoot using both LCD monitor and viewfinder. â If 5 minutes elapse in the Record-Standby mode, power shuts off automatically to conserve energy and protect the heads. To turn the camcorder on again, push back and pull out the viewfinder again or close and re-open the LCD monitor. As long as you donât take out the tape you were using or play it back, you can continue from where you left off with no noticeable break on the recorded video. â When a blank portion is left between recorded scenes on the tape, the time code is interrupted
Press START/STOP again to stop recording. â¢The camcorder re-enters Record-Standby mode. â â
5 END RECORDING
When youâre finished recording, push back the viewfinder or close the LCD monitor until it clicks; the lens cover closes and the power lamp goes out. â¢When transporting, make sure the viewfinder is pushed back and the LCD monitor is closed and locked. â¢To turn power on again, pull out the viewfinder or open the LCD monitor.
Set the Power Dial to âOFFâ. â¢When turning to âOFFâ, it is not necessary to press down the lock button. â
and errors may occur when editing the tape. Continue recording from where you stop so there are no gaps by following âRecording from the middle of a tapeâ ( pg. 20). Record-Standby means that a tape is loaded and the camcorder is ready to record. During recording, sound is not heard from the speaker. If you want to hear the sound, connect optional headphones to the headphones jack. The sound volume at this point is the same as the level it was adjusted during playback. To make the indications disappear, press and hold the IND.ON/OFF button for more than approx. 1 second. However, it is impossible to remove the tape running indicator â 444â and warning indications and so on ( pg. 81). Use the viewfinder when under direct sunlight or when reflections make it difficult to see the LCD monitor. When the battery remaining power indicator appears as , that means the battery power is close to nil. When the battery power is exhausted, power turns off automatically.