There are currently no product reviews.
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
Clear and easy to read. All details as expected. Price acceptable , and quick delivery.
VIDEO RECORDING EN
Before continuing, perform the procedures listed below: â Power ( pg. 11) â Loading A Cassette ( pg. 14) Power Switch Lock Button POWER/CHARGE Lamp Tally Lamp (Lights while recording is in progress.)
Tape Remaining Time
Approximate tape remaining time appears on the display. ââ h â â mâ means the camcorder is calculating the remaining time. When the remaining time reaches 2 minutes, the indication starts blinking.
â The time required to calculate and display the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.
LCD Monitor And Viewfinder
While using the LCD monitor: Make sure the viewfinder is pushed back in. Pull on the bottom end of the LCD monitor to open it. It can rotate 270Â° (90Â° downward, 180Â° upward). While using the viewfinder: Make sure the LCD monitor is closed and locked. Pull out the viewfinder fully.
Power Zoom Lever
Recording Start/Stop Button
1 Remove the lens cap. ( pg. 10) 2 Open the LCD monitor fully. 3 Set the VIDEO/MEMORY Switch to âVIDEOâ. 4 Set the Power Switch to âAâ or âMâ while pressing
down the Lock Button located on the switch.
â The POWER/CHARGE lamp lights and the camcorder enters the Record-Standby mode. âPAUSEâ is displayed. â To record in LP (Long Play) mode, pg. 27, 28.
5 To start recording, press the Recording Start/Stop Button. The tally lamp lights and âT RECâ appears on the display while recording is in progress. 6 To stop recording, press the Recording Start/Stop Button again. The camcorder re-enters the RecordStandby mode.
Approximate recording time
Tape 30 min. 60 min. 80 min. 30 min. 60 min. 80 min. Recording mode SP 45 min. 90 min. 120 min. LP
â The image will not appear simultaneously on the LCD monitor and the viewfinder except during Interface Shooting. ( pg. 16) When the viewfinder is pulled out while the LCD monitor is opened, you can select which one to use. Set âPRIORITYâ to the desired mode in SYSTEM Menu. ( pg. 27, 29) â Colored bright spots may appear all over the LCD monitor or the viewfinder. However, this is not a malfunction. ( pg. 46)
â If the Record-Standby mode continues for 5 minutes, the camcorderâs power shuts off automatically. To turn the camcorder on again, push back and pull out the viewfinder again or close and re-open the LCD monitor. â When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors may occur when editing the tape. To avoid this, refer to âRecording From The Middle Of A Tapeâ ( pg. 17). â To turn the tally lamp or beep sounds off, pg. 27, 29.
VIDEO RECORDING & PLAYBACK
Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…