There are currently no product reviews.
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! DziΔkujemy za!
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
The product manual I received was exactly what I was looking for, delivered painlessly at a very fair price. I can't ask for any more than that.
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Last week I bought a second hand BAUKNECHT TRK4850 DRYER. It is a professional machine with many programs and switch options. I feared it would be a huge quest to find a manual. I was delighted when I found owner-manuals.com. After payment I received the file to download the next day already. The quality is great. I am very happy. Thanks!
but kindly the distributions of the operating programs not find in the owners manual,can you help me to understand the operating programs instructions thank you
VIDEO RECORDING EN
Before continuing, perform the procedures listed below: â Power ( pg. 11) â Loading A Cassette ( pg. 14) Power Switch Lock Button POWER/CHARGE Lamp Tally Lamp (Lights while recording is in progress.)
Tape Remaining Time
Approximate tape remaining time appears on the display. ââ h â â mâ means the camcorder is calculating the remaining time. When the remaining time reaches 2 minutes, the indication starts blinking.
â The time required to calculate and display the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.
LCD Monitor And Viewfinder
While using the LCD monitor: Make sure the viewfinder is pushed back in. Pull on the bottom end of the LCD monitor to open it. It can rotate 270Â° (90Â° downward, 180Â° upward). While using the viewfinder: Make sure the LCD monitor is closed and locked. Pull out the viewfinder fully.
Power Zoom Lever
Recording Start/Stop Button
1 Remove the lens cap. ( pg. 10) 2 Open the LCD monitor fully. 3 Set the VIDEO/MEMORY Switch to âVIDEOâ. 4 Set the Power Switch to âAâ or âMâ while pressing
down the Lock Button located on the switch.
â The POWER/CHARGE lamp lights and the camcorder enters the Record-Standby mode. âPAUSEâ is displayed. â To record in LP (Long Play) mode, pg. 27, 28.
5 To start recording, press the Recording Start/Stop Button. The tally lamp lights and âT RECâ appears on the display while recording is in progress. 6 To stop recording, press the Recording Start/Stop Button again. The camcorder re-enters the RecordStandby mode.
Approximate recording time
Tape 30 min. 60 min. 80 min. 30 min. 60 min. 80 min. Recording mode SP 45 min. 90 min. 120 min. LP
â The image will not appear simultaneously on the LCD monitor and the viewfinder except during Interface Shooting. ( pg. 16) When the viewfinder is pulled out while the LCD monitor is opened, you can select which one to use. Set âPRIORITYâ to the desired mode in SYSTEM Menu. ( pg. 27, 29) â Colored bright spots may appear all over the LCD monitor or the viewfinder. However, this is not a malfunction. ( pg. 46)
â If the Record-Standby mode continues for 5 minutes, the camcorderâs power shuts off automatically. To turn the camcorder on again, push back and pull out the viewfinder again or close and re-open the LCD monitor. â When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors may occur when editing the tape. To avoid this, refer to âRecording From The Middle Of A Tapeâ ( pg. 17). â To turn the tally lamp or beep sounds off, pg. 27, 29.
VIDEO RECORDING & PLAYBACK
Complete service manual in digital format (PDF File). Service manuals usually contains circuit diagr…