There are currently no product reviews.
excellent quality, contains circuits and scan quality, 110 pages
It was easy done, and I got exactly what I was looking for.
The manuel was exactly what I needed and I received it promptly. Thanks
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
Great to be able to set channels again, on an old but stoll fine working TV
USING THE REMOTE CONTROL UNIT (cont.)
You can record a new scene onto a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.
Use the RM-V700U remote control unit to perform this procedure.
1 SELECT OPERATION MODE 2 FIND EDIT-OUT POINT
REW (2) Button FF (3) Button PLAY/PAUSE (4/6) Button STOP (5) Button COUNTER R/M Button
Set the Power Switch to âPLAYâ.
Play back the tape, locate the point and press PAUSE on the camcorder or the remote control. Press and hold COUNTER R/M for more than 1 second to reset the tape counter, then press again for less than 1 second so that âMâ appears.
3 RESET COUNTER
4 FIND EDIT-IN POINT
M 0 : 12 : 34
Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE exactly at the point where the new scene should start.
Insert editing indicator
5 ENGAGE INSERT EDITING MODE 6 BEGIN INSERT EDITING 7 END INSERT EDITING
Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert Editing mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step. Press START/STOP. When the counter reaches â0:00:00â, editing stops automatically and the camcorder enters the Insert-Pause mode.
START/STOP PAUSE STOP INSERT
â During Insert Editing, the original audio will be heard from the speaker. â After step 5, Retake ( pg. 17) can be performed. â The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit. â Only the video signal is recorded in the Insert Editing mode.