There are currently no product reviews.
It is perfect, exactly what we needed. It's like the paper version but less clutter.
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Immediate response with excellent service - highly reccommended
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
This camcorderâs 2-way power supply system lets you choose the most appropriate source of power. Do not use provided power supply units with other equipment.
2 Push in.
CHARGING THE BATTERY PACK
BATTERY RELEASE Switch REFRESH Button REFRESH Lamp CHARGE Lamp
Make sure the battery pack is attached to the camcorder. Hook its end to the camcorder 1 and push the battery in until it locks in place 2. â¢If the battery pack is attached in the wrong position, a malfunction may occur. Set the Power Switch to âOFFâ. Connect the AC Adapter to the camcorder 3, then connect the Power Cord to the AC Adapter 4. Plug the Power Cord into an AC outlet 5. The CHARGE lamp on the camcorder blinks to indicate charging has started. When the CHARGE lamp stops blinking but stays lit, charging is finished. Unplug the Power Cord from the AC outlet. Disconnect the AC Adapter from the camcorder.
2 3 4
3 To DC IN
Power Switch To AC outlet
To Detach The Battery Pack . . . .... slide BATTERY RELEASE and pull out the battery pack.
NOTES: â During charging or discharging, the camcorder cannot be operated. â Charging and discharging is not possible if the wrong type of battery is used. â When charging the battery pack for the first time or after a long storage period, the CHARGE lamp may not light. In this case, remove the battery pack from the camcorder, then try charging again. â If the battery operation time remains extremely short even after having been fully charged, the battery is worn out and needs to be replaced. Please purchase a new one. â Using the optional AA-V15EK AC Power Adapter/ Charger, you can charge the BN-V11U/V12U/V20U/ V400U battery pack without the camcorder. However, it cannot be used as an AC adapter.
Battery pack BN-V11U* BN-V12U (optional) BN-V20U** (optional) BN-V400U (optional)
Charging time approx. 1 hr. 10 min. approx. 1 hr. 10 min. approx. 1 hr. 50 min. approx. 3 hrs. 40 min.
* GR-SXM55 only. **Provided with GR-SXM607 only.
Charging a battery with some charge remaining reduces that batteryâs capacity. Perform the procedure below to fully discharge the battery pack before recharging. 1. Perform steps 1 through 3 of âCHARGING THE BATTERY PACKâ. 2. Press REFRESH on the camcorder for over 2 seconds. The REFRESH lamp on the camcorder blinks to indicate discharging has started. 3. When discharging is finished, charging automatically starts and the CHARGE lamp blinks. When you are not using a battery pack for a long period of time, be sure to fully discharge it before storing because leaving a battery with some charge left over also reduces performance.
For other notes,