Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
We received the manual in a timely manner and it was exactly what we were expecting.
Text excerpt from page 9 (click to view)
(S5a)
(WR4) A/C head base
Note: When installing the MECHA assembly, secure the screws (S4a) in the order of a , b .
5
(S4) <Note 4>
(S4b)
WR4 Foil side <Note 3>
b
a
(S4c)
A
(S5b)
(L5b)
4 Q3002 End sensor <Note 4> CN2001
(L5a)
D3001 LED <Note 4>
Fig. D4
Note 1: � Make sure that the (L5a) remains mounted on the main board during assembly. Note 2: � If you hold with your hands the RF connector and A , and apply some pressure to turn them counterclockwise, you can then remove the main board. Note 3: � It is feared that the main board may be broken if it is removed due to the presence of some cutout blanks, especially when it is removed with a machine mounted on it.