The Service Manual received was helpful. The electronic information is exactly what I needed.
Text excerpt from page 4 (click to view)
FINAL ASSEMBLY <M2>
BEWARE OF BOGUS PARTS Parts that do not meet specifications may cause trouble in regard to safety and performance. We recommend that genuine JVC parts be used. 516
NOTE) INERTIA PLATE should be attached so as to ser small diameter of central round hole above.
519A 515 519
MECHANISM ASSY<M4> 516
NOTE) When attaching ROLLER ARM ASS'Y, attach the hook(L3c) before the spring(P3a). NOTE) After attached ROLLER ARM ASS'Y, tighten screw(S3g) with slit washer(W3a).
503 MAIN BOARD ASSY<03>
Q 30 03
Insert the bushing of POWER CORD so as not to twist the cord.
D 30 01
CN5 00 1
1 00 JS 3
<Phase alignment> Accord the position of V gap on R. Encoder and PWB silk " ". Accord the position of Boss on R. Encoder and PWB silk " ".
k h a f g d' c' b f b c'
For the prevention of the DRUM FPC damage. When you attach the MECHA UNIT on B. CHASSIS. Attach the MECHA UNIT after the positioning boss "z" of the B. CHASSIS is matched to the positioning hole of the MECHA UNIT.
To main CN7001
ADV. JOG BOARD ASSY<38>
Front panel back side
ONLY USED FOR HR-S6955EK
From CAPSTAN MDA Right side
1. Insert direction of FCC WIRE as follows. Right side Back side
2. FFC WIRE and DRUM FPC WIRE should be insert as follows. OK NG 90