|
Who's Online
There currently are 5884 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Manual was just as described!!! I odered it and in less than a day was able to download it and the text was clear and pages were all complete just as the original manual was. Purcashed this for a friend and they were more than happy. Perfect all around!
;
Excellent service and prompt delivery. But it's not a manual - only 4 pages wiring diagrams.
Thanks.
;
The manual I purchased was exactly what I needed to repair my Toshica television. The manual contained schematics and troubleshooting information that was very helpful.
;
Il download del Service Manual JVC HR 4100 non é stato eseguito
;
The Service Manual was just as expected, complete with schematics and I was able to download it in less than an hour after I ordered it. The only problem with these is that the schematics are hard to read due to the small font. I could remedy this by printing them on a larger printer.
SECTION 3 ADJUSTMENT
The difference point(s) compared with the reference model are as follows.
DELETE
3.3.2 Video circuit 3.3.2.1 3.3.4.1 3.3.4.2 EE Y/PB Y (S-VHS/VHS) LEVEL Colour difference level SECAM burst position 3.3.4 PAL/SECAM converter circuit [EF model]
Adjustment procedure and value are changed.
3.3.1 Servo circuit 3.3.1.1
Signal Mode Equipment Measuring point External trigger Adjustment part Specified value Adjustment tool
Switching point
(A1) (A2) (B) (C) (D1) (D2) (E) (F) (G) (H) � � � � � � � � � � Stairstep signal Alignment tape(LP,stairstep,PAL) [MHPE-L] PB Oscilloscope VIDEO OUT terminal (75 ohm terminated) TP106 (PB. FM) TP111 (D.FF) Jig RCU: Code �5A� 6.5 ± 0.5H Jig RCU [PTU94023B]
(1) Play back the signal (A1) of the alignment tape (A2). (2) Apply the external trigger signal to D.FF (E) to observe the VIDEO OUT waveform and V.PB FM waveform at the measuring points (D1) and (D2). (3) Set the VCR to the manual tracking mode. (4) Adjust tracking so that the V.PB FM waveform becomes maximum. (5) Set the VCR to the Auto adjust mode by transmitting the code (F) from the Jig RCU. When the VCR enters the stop mode, the adjustment is completed. (6) If the VCR enters the eject mode, repeat steps (1) to (5) again. (7) Play back the alignment tape (A2) again, confirm that the switching point is the specified value (G).
Trigger point Switching point V.sync
V. rate
Fig.3-3-1a Switching point
(No.82979)1-5
|
|
|
> |
|