Everything was ok with the manual. If I have a small complaint, is that I ordered it during the weekend and I think you guys were closed. But I did receive it late Sunday. I will surely order from you again
Very good quality, no parts are missing and everthing is readable.
Thank you very much. :-)
Text excerpt from page 22 (click to view)
3.3.9 Removing the cams R1/R2 assembly and cam gear q (See Fig.22) (1) Remove the slit washer fixing the cams R1 and R2 assembly. (2) By removing the two pawls w fixing the cam R1, separate R2 from R1. (3) Remove the slit washer fixing the cam gear q . (4) Pull out the cam gear q from the C.G. base assembly. 3.3.10 Removing the C.G. base assembly (See Fig.22 and 23) (1) Remove the three screws J retaining the C.G. base assembly. CAUTION: To reassemble the cylinder gear, etc.with the cam unit (cam gear and cans R1/R2 assembly), gear unit and drive unit, align the position of the pawl x on the drive unit to that of the notch on the cam gear q . Then, make sure that the gear unit is engaged by turning the cam gear q .
