perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Super nice! Good to have a manual in digital format.
Text excerpt from page 24 (click to view)
SOUND ADJUSTMENTS
ENGLISH
Adjusting the sound
You can set the speaker output balance, subwoofer output level, and input level of each source. � There is a time limit in doing the following procedure. If the setting is canceled before you finish, start from step 1 again.
2
Make adjustments.
� To adjust fader and balance�Fad, Bal: You can make these two adjustments at the same time. � If you are using a two-speaker system, set the fader level to �00.� � Press 5 (up) or � (down) to adjust the fader. � Press ¢ or 4 to adjust the balance.
1
Select the item you want to adjust.
The next-step-operation buttons start flashing. Each time you press the button, the adjustable items change as follows:
iEQ
Fad/Bal
Sub Out
� To adjust subwoofer output�Sub Out: This takes effect only when a subwoofer is connected.
Canceled
Theme
Vol Adj
To increase the level To decrease the level
� For iEQ (sound mode) settings, see pages 25 � 27. � For THEME (display theme) settings, see page 28. Indication Fad To do: Adjust the front and rear speaker balance. Adjust the left and right speaker balance. Range R06 (Rear only) | F06 (Front only) L06 (Left only) | R06 (Right only)
Bal
You can also set an appropriate cutoff frequency level according to the subwoofer connected. � Press ¢ or 4 �Mid,� or �High.� Low: Mid: to select �Low,�
Sub Out
Adjust the 00 (min.) subwoofer output | level and cutoff 12 (max.) frequency level. Low/Mid/High Adjust and store the input level of each source. �12 (min.) | +12 (max.)
Frequencies higher than 50 Hz are cut off to the subwoofer. Frequencies higher than 80 Hz are cut off to the subwoofer.
Vol Adj
High: Frequencies higher than 115 Hz are cut off to the subwoofer.