|
Who's Online
There currently are 6042 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I am very happy with the owner's manual. I bought a used Casio and was so relieved that I was able to get a hold of a owner's manual. It was very easy to download the manual and I had no problems with printing it. Thank you! Nancy Whalen
;
The purchased manual is an high-quality scan of the original JVC paper-based Owner´s Manual. I am very satisfied!
;
Very satisfied with received document, all is right, Thank You very much, it was a Pleasure to work with You.
;
great site, the most easy and fastest way to find the manual you need, no 5 star because the manual was only available in german, but I speak german as well so no problem for me.
;
thanks for this download i got a pioneer bdp-lx70a blu-ray player and it had no manual i search everywhere on the internet and came across owner-manuals.com and i found that it was so easy to find and downloaded from this site if i ever need a manual again this would be the first place that i would come too thanks guys
MX-G500
Disassembly method
Removing the metal cover (See Fig.1)
1. Remove the three screws A attaching the metal cover on the back of the body. 2. Remove the six screws B attaching the metal cover on the both sides of the body. 3. Remove the metal cover from the body by lifting the rear part of the cover. ONE POINT How to eject the CD tray (see fig.2) Although it will end if the OPEN/CLOSE button is pushed when a power supply can be taken, when that is not right, CD tray will be opened manually. Turn the loading pulley gear at the bottom of the CD changer unit as shown in Fig.2 and draw the CD tray toward the front.
Metal cover
A
B
(both sides)
Fig.1
Loading pulley gear (See <CD changer unit>fig.1)
Removing the CD Tray fitting (See Fig. 3)
Prior to performing the following procedure, eject the CD tray. 1. After drawing the lower part of the tray fitting toward the front, remove the five claws. Then, while moving the tray fitting upward, remove it.
CD tray fitting
Fig.2
Joint
Removing the CD changer unit (See Fig.4 to 7)
Prior to performing the following procedure, remove the metal cover. 1. Remove the card wire attached to CD changer unit on the adhesion tape.
Claw
2. Disconnect the card wire from the connector CW107 on the CD servo board. 3. Disconnect the harness from the connector RCW6 on the main board and CW105 on the CD servo board. 4. Remove the two screws C attaching the CD changer unit to the rear panel. 5. Remove the two screws D attaching the CD changer unit to the both side of front panel assembly. 6. Draw the CD changer unit upward from behind while pulling the rear panel outward.
Adhesion tape
Fig.3
CD changer unit
Card wire
Fig.4 1-5
|
|
|
> |
|