There are currently no product reviews.
Manual was complete and available promptly, since I had lost my original manual. Very good response.
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
excellent quality, contains circuits and scan quality, 110 pages
It was easy done, and I got exactly what I was looking for.
The manuel was exactly what I needed and I received it promptly. Thanks
Adjusting the sound
You can adjust the sound characteristics to your preference.
Adjust the level.
To increase the level.
Select the item you want to adjust.
Each time you press the button, the adjustable items change as follows:
To decrease the level.
Note: Normally, the control dial works as the volume control. So you do not have to select âVOLâ to adjust the volume level.
Adjust the bass.
â06 (min.) | +06 (max.) â06 (min.) | +06 (max.) R06 (Rear only) | F06 (Front only) L06 (Left only) | R06 (Right only) LOUD ON | LOUD OFF 00 (min.) | 50 (max.)
Using the sound control memory
You can select and store a preset sound adjustment suitable for each playback source (Advanced SCM).
Adjust the treble.
Adjust the front and rear speaker balance. Adjust the left and right speaker balance. Boost low and high frequencies to produce a wellbalanced sound at low volume level. Adjust the volume.
Selecting and storing the sound modes
Once you select a sound mode, it is stored in memory. It will be recalled every time you select the same source and will be shown on the display. A sound mode can be stored for each of the following sources â FM1, FM2, FM3, AM, tape and external components. â¢ If you do not want to store the sound mode separately for each playback source, but want to use the same sound mode for all the sources, see âTo cancel Advanced SCM â SCM LINKâ on page 21.
Select the sound mode you want.
Each time you press the button, the sound mode changes as follows:
* If you are using a two-speaker system, set the fader level to â00.â