|
|
|
Who's Online
There currently are 5962 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent quality service manual. Quick processing, fair prices. Love to do business again. Thank you!!!
;
Excellent service manual, the only known point of note is the alignment of improvability scanned pages within the pdf page. The resolution is good.
;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
;
It was just what I need to fix my old BMW's CD player. Very convenient also. Thank you.
KS-FX922R
Removing the head relay board (See Fig.4)
1. Unsolder the soldering b on the head relay board. 2. Remove the screw C attaching the head relay board. 3. Remove the head relay board in the direction of the arrow while releasing the two joints c. Fig.4
Cach
Head relay board
Joint c
C
Soldering b
Removing the load arm (See Fig.5)
1. Remove the E washer attaching the load arm using a pincette or something like that and remove the spring d. 2. Move the part of the load arm marked upwards to release it from the axis of rotation. Then rotate the load arm in the direction of the arrow to remove it from the cach.
Load arm E washer Spring d
Fig.5
Removing the sub chassis (See Fig.6)
Prior to performing the following procedure, remove the head relay board. 1. Remove the screw D attaching the sub chassis. 2. Push the tab e in the direction of the arrow to detach the one side of the sub chassis. Then release the sub chassis from the tab f.
Tab f Tab e Head relay board
D
Fig.6
Reinforce bracket
Removing the cassette holder and the holder arm in the eject mode (See Fig.7 and 8)
Prior to performing the following procedure, remove the head relay board, the load arm and the sub chassis. 1. Remove the screw E attaching the reinforce bracket. 2. Remove the reinforce bracket. 3. Push the tab g fixing the cassette holder in the direction of the arrow and open the cassette holder and the holder arm upward until they stop at an angle of 45 degrees. Move the two joints h to the side and remove the cassette holder and the holder arm from the shaft.
Sub chassis
Cassette mecha chassis Cassette holder
E
Reinforce bracket tab g
Head relay board
Joint h
Load arm Holder arm
Joint h
Fig.7
1-7
|
|
|
> |
|
