|
|
|
Who's Online
There currently are 5991 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I'm very satisfied with my purchase. It resolved my problem. Owner-manuals.com is a very very good place.
Thank you!
 ;
Veramente completo, dettagliato e perfetto nella visione. Perfect, thanks!
;
Fully functional usable service manual. Considering the age of the manual and device quality was better than expected
;
Thank you very much, I've been very happy to find this manual on "Owner Manual". It's a perfect copy and it has been really useful for my work!
;
It took about 24-hours after my payment before I was able to get to the download. Apparently, payment processing is not 100% automated. That is no big deal, just be aware of that going in.
After I got to it, it was in good shape, easy to read, etc. Not some cheap FAX copy looking thing.
Also, this site was the cheapest I found. Another Plus!
MP-XP7220KR,MP-XP5220KR
1.1.6 Removing the top case and the LCD panel assembly (See Figure 16) � Prior to the following procedure, remove the top case and the LCD panel assembly from the bottom case. (1) Remove the two screws N attaching the hinge. (2) Remove the tapes fixing the two wires of the LCD panel assembly if necessary.
Rubber pad and screw O Latch
N
Hinge
Tape
Tape
Hinge
N Latch
LCD
Latch
Latch
Fig.16 1.1.7 Removing the LCD panel (See Figure 17 and Figure 18) � Prior to the following procedure, remove the LCD panel assembly. (1) Remove the two rubber pads (fixed to the panel with adhesive tapes) by using a sharp tool. (2) Remove the two screws O attaching the LCD panel frame. (3) Lift and the centers of the four sides of the LCD panel from inside to an outward direction. (It is soft enough to be lifted.) Then, latches in the centers of the four sides and also other latches are removed. To remove all the latches, lift the four sides from inside to an outward direction. * Be careful not to damage the LCD or apply any stress to the LCD. (4) Remove the two screws P attaching the LCD. (5) Remove one screw Q attaching the inverter board, and disconnect the socket wire from the connector CN2 on the inverter board. Fig.17
LCD
P P
Q CN2
Inverter board
Fig.18
1-6 (No.G1004)
|
|
|
> |
|
