|
Who's Online
There currently are 5642 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
;
Great Job!!! clear and efficient as always!!
it is really nice to have peple that are doing such a good work!!!!!
;
I must admit, I was very skeptical... $4.99 for a 74 page service manual. I've seen some very poorly scanned manuals on the Internet, but this one is VERY good quality! Even when zooming into 500%. Great Deal!
MX-DVB10
Removing the AV output board (See Fig.22, 23)
Prior to performing the following procedures, remove the metal cover, the tuner board, the DVD changer mechanism assembly, the rear panel, the amplifier board (1,2) and the power supply board. 1. Disconnect the connector CN705, CN372 and CN373 on the amplifier board (1, 2).
Fan
AV output board
Fan bracket CN705
2. Remove the two screws marked J attaching the AV output board to the fan bracket. 3. Pull out the fan bracket from the AV output board. amplifier board (1) Fig.22
AV output board CN372 Hook CN373
amplifier board (2)
J
Heat sink
Removing the Heat sink (See Fig.24)
Prior to performing the following procedures, remove the metal cover, the tuner board, the power supply board, the DVD changer mechanism, assembly the rear panel, the tuner board, the amplifier board (1,2) and AV output board. 1. Remove the eight screws marked K attaching the ICs on the heat sink. Amp. board (1, 2)
Fig.23 Heat sink
K K
Removing the ICs
(See Fig.25)
Fig.24
Solder points
Prior to performing the following procedures, remove the metal cover, the tuner board, the DVD changer mechanism assembly, the rear panel, the tuner board, the AV output board, the amplifier board (1,2), the power supply board and the heat sink.
Solder points
1. Unsolder the ICs solder points. 2. Remove the ICs. Fig.25
1-11
|
|
|
> |
|