There are currently no product reviews.
This manual was the factory original. Excellent value and contained all the details I needed. Easy dowwnload provided the information when I needed it.
Impeccable, document très complet. Perfect, i get all i need. All schematic are correct. Thanks
The manual is of better quality compared to other. I found it less expensive and therefore it it is the best buy cost vs quality.
I bought the service-manual of the sony ICB-1020(an old transmitter-receiver) at "www.Owners-Manual.com", I found the service-manual for a fairly cheap price(in comparison with other sellers). I filled in some questions, payed the order with Ideal, and within 24 hours I had my service manual. I was very happy:In no time I had my service-manual and everything, but literally everything was noted down in the manual; the electronic scheme, the parts list, etcetera.
A very practical, reference-document.
This comprehesive service maual was greatly appreciated, as was the digital download.
Removing the heat sink & AMP board (See Fig.14 and 15)
Prior to performing the following procedure, remove the metal cover and the CD changer unit. 1. Remove the four screws I attaching the heat sink cover on the back of the body. Remove the heat sink cover. 2. Remove the four screws J attaching the heat sink & AMP board to the rear panel on the back of the body. 3. Remove the two screws K attaching the speaker terminal to the rear panel on the back of the body. 4. Disconnect the card wire from connector ACW1 and the harness from connector ACW2 on the AMP board. (See Fig.11) 5. After moving the heat sink upward, remove the claws. Then pull out the heat sink & AMP board inward.
Heat sink cover
Removing the tuner pack (See Fig.15 and 16)
Prior to performing the following procedure, remove the metal cover and CD changer unit. 1. Disconnect the card wire from connector CON01 on the tuner board. 2. Remove the two screws L attaching the tuner pack.
Removing the rear cover
Prior to performing the following procedure, remove the metal cover, CD changer unit, heat sink & AMP board and tuner pack. 1. Remove the fore screws M and one screw M' (Only MX-G50 J / MX-G56 C) attaching the rear panel.
Main board CON01
Optical out only MX-G50 J MX-G56 C