There are currently no product reviews.
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
Fast service, document is OK. Thanks! Searched for it long time.
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! DziÄkujemy za!
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Turning On or Off the Power
To turn on the unit, press STANDBY/ON so that the STANDBY lamp goes off.
To check the clock time
Press and hold SET/DISPLAY while playing any source. â¢ Each time you press and hold the button, the source indication and the clock time alternate on the display.
To adjust the clock again
If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected. â¢ Each time you press the button, the clock/timer setting modes change as follows:
DAILY Canceled ON TIME Clock setting REC ON TIME
To turn off the unit (on standby), press STANDBY/ON again so that the STANDBY lamp lights up.
â¢ A little power is always consumed even while the unit is on standby. To switch off the power supply completely, unplug the AC power cord from the AC outlet.
When you unplug the AC power cord or if a power failure occurs The clock is reset to â0:00â right away, while the tuner preset stations (see page 12) will be erased in a few days.
(The hour digits start flashing.)
When you unplug the AC power cord or if a power failure occurs The clock loses the setting and is reset to â0:00.â You need to set the clock again.
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.
Setting the Clock
Before operating the unit any further, first set the built in clock. You can set the clock whether the unit is on or off.
On the unit ONLY:
You can only change the AM tuner interval spacing while tuning into an AM station. (See page 12.) Press STANDBY/ON while holding down 7. â¢ Each time you press these buttons, the AM tuner interval spacing alternates between 9 kHz and 10 kHz.
On the unit ONLY:
1 Press CLOCK/TIMER.
The hour digits start flashing on the display.
2 Turn 4/Â¢ to adjust the
hour, then press SET/ DISPLAY.
The minute digits start flashing on the display.
Selecting the Sources
To listen to the FM/AM broadcasts, press FM/AM. (See page 12.) To playback CDs, press CD 3Â¥8 SELECT. (See pages 13 â 16.) To playback tapes, press TAPE 2 3. (See page 21.) To select the external equipment as the source, press AUX.
â¢ If you want to correct the hour after pressing SET/DISPLAY, press CANCEL/DEMO. The hour digits start flashing again.
3 Turn 4/Â¢ to adjust the minute, then
When you press the play button for a particular source (FM/AM, CD 3/8 SELECT, TAPE 2 3, and AUX), the unit turns on (and the unit starts playing the source if it is ready â COMPU PLAY CONTROL).
About the audio level indicator All the audio level indicators light up when no signals come in.