- Safety Precautions
- Important for Laser Products
- Precautions at Disassembling and Parts Replacement
- Disassembly Method
- Adjustment Method
- Diagnosis which Uses Extension Wire Method
- Flow of Functional Operation until TOC Read
- Maintenance of Laser Pickup
- Replacement of Laser Pickup
- Description of Major ICs
- Block Diagrams
- Standard Schematic Diagrams
- Printed Circuit Boards
- Parts List
There are currently no product reviews.
First class Service,
best quality, come again
I didn't realise a manual for an early plasma TV such as the one we were gifted could be so easily obtained. No manual was supplied with it, and as senior citizens we were a little puzzled over some aspects of its use. I do not want a listing for your store credit as we are not fairly big computer users. The manual was well organised, as it should be, with its backing of the Pioneer name. The download was prompt and everything worked quite smoothly. Thank you. Gordon.
Thank you very much for the manual. It is what I needed and it will be very helpful to me. The delivery of the manual was easy and very fast. I strongly recommend this site to other users. Best regards.
Excellent!! Got what I need and very fast!! Thank You
Manual acquired with good resolution, complete in all its pages, very good policy of the folder where are saved all products purchased.
<Rear panel assembly> Removing the tuner board (See Fig.19 and 20)
Prior to performing the following procedure, remove the metal cover. 1. Remove the two plastic rivets attaching the joint board, and remove the joint board. 2. Disconnect the card wire from connector CN1 on the tuner board. 3. Remove the two screws R attaching the tuner board on the back of the body.
CN712 S CN711 Input / output board Joint board Plastic rivets Tuner board CN1 Rear panel CN871
Removing the input / output board (See Fig.19 and 20)
Prior to performing the following procedure, remove the metal cover. 1. Remove the two plastic rivets attaching the joint board, and remove the joint board. 2. Disconnect the card wire from connector CN315 on the input / output board. 3. Remove the screw S attaching the input / output board on the lower right side of the body. 4. Remove the screw, E & F attaching the input / output board on the back of the body. 5. Disconnect connector CN870, CN871, CN711 and CN712 on the input / output board by pulling out them outward. Remove the input / output board from the body. Fig.20
(Only the model by which a digital output is installed)