There are currently no product reviews.
manual de usuario perfecto y completo de buena calidad de impresion y muy detallado ideal !
It`s full copy of a service manual from url http://www.philips.owner-manuals.com/PM3216-service-manual-PHILIPS.html
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
Super nice! Good to have a manual in digital format.
Using the Tuner
Select a station using one of the following methods.
â¢ Manual Tuning Briefly press the 22 or Ã button to move from frequency to frequency until you find the station you want. OR â¢ Auto Tuning If you hold down the 22 or Ã button for 1 second or more and then release it, the frequency changes down, or up, automatically until a station is found. OR â¢ Preset Tuning (Possible only after presetting stations) Preset tuning using the Unit: Select the preset number you want, using the 4 or Â¢ button.
Using the Unit
1 2 3 4
Select a band by pressing the FM/AM button. Press the 22 or Ã button to tune in a station. Press the SET button.
âSETâ will blink for 5 seconds.
While âSETâ is blinking, press the 4 or Â¢ button to select the preset number.
Â¢: 4: Increases the preset number by 1. Decreases the preset number by 1.
Press the SET button.
âSTOREDâ appears and, after 2 seconds, the display returns to the band/frequency display.
Press the Â¢ button until the preset number âP12â appears on the display. Then, the display will show the preset numberâs band and frequency.
Repeat above steps 2 to 5 for each station you want to store in memory with a preset number.
To change the preset stations, repeat the same steps as above.
Preset tuning using the Remote Control: Enter the preset number you want to recall using the numeric keys. See âEntering the Number with the Remote Controlâ on page 8. Press +10, then 2 to recall the preset number 12. Then, the display will show the preset numberâs band and frequency.
â¢ In step 4, you can select the preset number using the numeric keys on the Remote Control. See âEntering the Number with the Remote Controlâ on page 8.
â¢ Even if the System is unplugged or if the power failure occurs, the preset stations will be stored for a few days. However, in case the preset stations are erased, you will need to preset the stations again.
â¢ In AM broadcast, reception sensitivity will be changed by turning the AM loop antenna. Turn the AM loop antenna for best reception.
To Change the FM Reception Mode
When you are tuned in to an FM stereo broadcast, the âST (Stereo)â indicator lights up and you can hear stereo effects. If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose stereo effect. Press the FM MODE button on the Remote Control so that the âMONOâ indicator lights up on the display.
You can preset up to 30 FM stations and up to 15 AM stations.
â¢ Preset numbers may have been set to factory test frequencies prior to shipment. This is not a malfunction. You can preset the stations you want into memory by following one of the presetting methods below. â¢ During presetting stations, if no button operation is made for 5 seconds, the display returns to the band/frequency display. In this case, repeat steps from the beginning.
To restore the stereo effect, press the FM MODE button on the Remote Control so that the âMONOâ indicator goes off. Selecting other station will also cancel the FM Mono mode and restore the stereo effect.
When changing the Band