|
|
|
Who's Online
There currently are 5846 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
;
The manuel was exactly what I needed and I received it promptly. Thanks
Mounting the Wall Unit
Warning
x10
Plasma LCD Plasma LCD
â� The Wall Mounting Unit should be mounted to a wall that can adequately hold the total weight of the plasma/LCD display and the Wall Mounting Unit over a long period of time and which can adequately withstand earthquakes, conceivable vibrations, and other external forces. Improper installation may cause the Plasma/LCD display to fall down, resulting in physical injury. Mounting On Wooden Walls The weight of the unit should be borne by the wall posts or studs, and these should be reinforced if insufficiently strong. Do not install the Wall Mounting Unit on walls made of plasterboard or thin plywood. Use the commercially sold screws best suited for the wall structure and material. Mounting On Concrete Walls Use commercially sold wall anchors capable of supporting the weight of the plasma display.
ENGLISH
â� Do not install the Wall Mounting Unit in a location which is hot or humid or which may become wet, as the presence of excessive moisture may lead to fire or electric shock. â� Do not install the Wall Mounting Unit near the blower or air inlet of an air conditioner. â� Do not install the unit in a location with a large amount of dust, soot, or cigarette smoke, as this may lead to fire.
Minimum 15 cm
Minimum 20 cm
â� Do not block the ventilation holes, and be sure to leave sufficient space around the unit for ventilation. Inadequate ventilation may cause the unit interior to overheat, leading to fire.
â� Do not install the Wall Mounting Unit in a location subject to frequent vibration, impact or other external forces. The unit may fall down or be damaged, causing physical injury. â� Do not install the unit in a location where people may hang on it or lean against it. Doing so may cause the unit to fall down or be damaged, resulting in injury.
â� Do not install the Wall Mounting Unit on a nonvertical wall. The unit interior may overheat, resulting in fire, or the unit may fall down, causing physical injury.
â� Do not install the unit in a location exposed to direct sunlight or strong light, as viewing the plasma display in an overly bright environment can be tiring for the eyes.
3
|
|
|
> |
|
