|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
Basic Settings
English
Crossover frequency
Small speakers cannot reproduce the bass sounds efficiently. If you use a small speaker in any position, this receiver automatically reallocates the bass sound elements assigned to the small speaker to the large speakers. To use this function properly, set this crossover frequency level according to the size of the small speaker connected. � If you have selected �LARGE� for all speakers, this function will not take effect (�CROSS OFF� appears).
Low frequency effect attenuator
If the bass sound is distorted while playing back software using Dolby Digital or DTS Digital Surround, follow the procedure below: � This function takes effect only when the subwoofer (LFE) signals come in, (with �SUBWOOFER� set to �YES�).
1
1
Press SETTING repeatedly until �CROSS (Crossover)� (with the current setting)* appears on the display.
SETTING
Press SETTING repeatedly until �LFE ATT (Low Frequency Effect Attenuator)� (with the current setting)* appears on the display.
setting, ��10dB� will be shown.
SETTING
* �0dB� is the initial setting. If you have already changed the
* �150HZ� is the initial setting. If you have already changed the setting, another frequency will be shown.
2
Press CONTROL UP 5/DOWN � to select the low frequency effect attenuator level.
� Each time you press the button, the setting alternates between �0dB� and ��10dB.� 0dB �10dB : Normally select this.
CONTROL DOWN UP
2
Press CONTROL UP 5/DOWN � to select the crossover frequency level you like to use.
� Each time you press the button, the crossover frequency level changes as follows:
80HZ 200HZ 100HZ 120HZ 150HZ
CONTROL DOWN UP
: Select this when the bass sound is distorted.
Note: Crossover frequency is not valid for the HEADPHONE mode.
Dynamic range compression
You can compress the dynamic range (difference between maximum sound and minimum sound) of the reproduced sound. This is useful when enjoying surround sound at night. � This function takes effect only when playing back a source using Dolby Digital.
1
Press SETTING repeatedly until �D. COMP (Dynamic range compression)� (with the current setting)* appears on the display.
SETTING
* �MID� is the initial setting. If you have already changed the setting, another setting will be shown.
2
Press CONTROL UP 5/DOWN � to select the appropriate compression level.
� Each time you press the button, the display changes as follows:
OFF MAX MID
CONTROL DOWN UP
OFF : Select this when you want to enjoy surround with its full dynamic range. (No effect applied.) MID : Select this when you want to reduce the dynamic range a little.
MAX : Select this when you want to apply the compression effect fully. (Useful at night.)
14
|
|
|
> |
|