|
Who's Online
There currently are 5911 guests and 1 member online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
RX-6032VSL
2.14 Removing the power supply board (See Fig.16) � Prior to performing the following procedure, remove the top cover. (1) From the top side of the main body, disconnect the parallel wires from the connectors CN203 and CN241 on the power supply board. (2) Disconnect the card wire from the connector CN201 on the power supply board. (3) Disconnect the relay board from the connector CN291 on the power supply board. (4) Disconnect the parallel wire from the connector CN101 on the headphone jack board. (5) Remove the solders from the soldered section c on the power transformer board 1. (6) Remove the three screws S attaching the power supply board. (7) Remove the power supply board from the hook g of the chassis base bracket in the direction of the arrow, take out the power supply board. (8) Turn over the power supply board, remove the solders from the soldered sections h attaching the wires.
Card wire CN241
S
CN201
Power supply board Parallel wire
CN101 Parallel wires CN203 CN291 Headphone jack board
S
Soldered section h
Relay board
S
Soldered section c
Hook g of the chassis base bracket
Fig.16 2.15 Removing the headphone jack board (See Figs.16 and 17) � Prior to performing the following procedure, remove the top cover and front panel assembly. (1) From the top side of the main body, disconnect the parallel wire from the connector CN101 on the headphone jack board. (See Fig.16) (2) From the front side of the main body, remove the nut and screw T attaching the Bracket(phones) to the chassis base. (See Fig.17)
Power transformer board 1
Headphone jack board Nut Bracket(phones)
T
Chassis base
Fig.17
1-10 (No.22012)
|
|
|
> |
|