|
Who's Online
There currently are 5663 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Manual found fast and good quality, very helpfull service
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
;
very complete. acceptable resolution. details are a little unclear. is a manual note 8.
RX-7001PGD Removing the power supply board (See Fig.18 and 19)
Prior to performing the following procedure, remove the top cover and the front panel. 1. Remove the one nut attaching the headphone jack of the power supply board on the front side of the body. 2. Disconnect the relay board 1, 2 and 3 from the power supply board and the main board respectively. 3. Disconnect the harness connected to connector CN55 and CN56 on the power transformer board (If necessary, cut off the band fixing the harness on the side of the base chassis). 4. Remove the four screws O attaching the power supply board and pull out the power supply board from the front bracket backward. 5. Unsolder the three harnesses connected to the Relay board 2 power supply board.
Power supply board Nut Headphone jack
Fig.18
Power supply board Headphone jack Relay board 1
O
Solder
O
Solder
O
Tie band CN55 CN56 Tie band
Removing the system control board / power switch board (See Fig.20 to 21)
Prior to performing the following procedure, remove the top cover and the front panel assembly. 1. Pull out the volume knob on the front side of the front panel and remove the nut attaching the system control board. 2. Remove the six screws P attaching the system control board on the back of the front panel and disconnect the harness from connector CN422 on the system control board. 3. Disconnect the harness from connector CN430 on the power switch board.
Relay board 3
Power transformer
Fig.19
Nut Front panel
Volume knob
4. Remove the five screws Q switch board.
attaching the power
System control board
Fig.20
Power switch board
P
Q Q
P
CN422 Front panel assembly
CN430
P
Fig.21
1-7
|
|
|
> |
|