There are currently no product reviews.
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
Exactly as described, the full user-manual (145 pages). Perfect.
This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply.
â¢ Be sure your hands are dry. â¢ Turn the power off to all components. â¢ Read the manuals supplied with the components you are going to connect.
Putting Batteries in the Remote Control
Before using the remote control, insert the two supplied batteries first.
â¢ Install the receiver in a location that is level and protected from moisture. â¢ The temperature around the receiver must be between â5ËC and 35ËC. â¢ Make sure there is good ventilation around the receiver. Poor ventilation could cause overheating and damage the receiver.
1. Press and slide the battery cover on the back of the remote control. 2. Insert the batteries.
â¢ Make sure to match the polarity: (+) to (+) and (â) to (â).
Handling the receiver
â¢ Do not insert any metal object into the receiver. â¢ Do not disassemble the receiver or remove screws, covers, or cabinet. â¢ Do not expose the receiver to rain or moisture.
3. Replace the cover.
If the remote control cannot transmit signals or operate the receiver correctly, replace the batteries. Use two R6P(SUM-3)/AA(15F) type dry-cell batteries.
Checking the Supplied Accessories
Check to be sure you have all of the following items, which are supplied with the receiver. The number in the parentheses indicates quantity of the pieces supplied. â¢ â¢ â¢ â¢ Remote Control (1) Batteries (2) AM Loop Antenna (1) FM Antenna (1)
â¢ Supplied batteries are for the initial setup. Replace the batteries for continued use. â¢ After replacing the batteries, set the manufacturersâ codes again (see pages 45 to 48).
Follow these precautions to avoid leaking or cracking cells: â¢ Place batteries in the remote control so they match the polarity: (+) to (+) and (â) to (â). â¢ Use the correct type of batteries. Batteries that look similar may differ in voltage. â¢ Always replace both batteries at the same time. â¢ Do not expose batteries to heat or flame.
If anything is missing, contact your dealer immediately.