Genuine Toshiba owner's manual. Couldn't really ask for more. And written in understandable English in contrast to a few recent experiences I have had with manuals for other equipment other than Toshiba but made in China and written in "Chinglish"!
I purchased a vintage Sony mixer off eBay and within the hour was able to locate and purchase the manual for it.I mean really,where else can you find a manual for a product made in 1983!? It was easy to find and purchase/download the manual I needed.I will use this site again for other equipment I have! Great site!
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Text excerpt from page 43 (click to view)
5. Adjust the speaker output levels as follows: � To adjust the center speaker level, press CNTR +/�. � To adjust the left rear speaker level, press REAR�L +/�. � To adjust the right rear speaker level, press REAR�R +/�.
ENTER
CNTR
MENU
2
REAR L
3
REAR R
Notes:
� You can adjust the speaker output levels and center tone
5
6
8
9
6. Press TEST again to stop the test tone.
TEST
4
7. Press CNTR TONE to select the center tone level you want. The center tone adjustment affects the mid-frequency range, which the human voice is mostly made up of. Each time you press the button, the display changes to show the following: SOFT2 SOFT1 FLAT SHARP1
CNTR TONE
without outputting the test tone. � You cannot adjust the center speaker level when �CENTER SPK� is set to �NONE� (see page 20). � You cannot adjust the rear speaker levels when �REAR SPK� is set to �NONE� (see page 20).
Note:
The center tone cannot be adjusted when �CENTER SPK� is set to �NONE� (see page 20).
1
SHARP2
Adjusted level are also shown on the on the equalizer display.
This CNTR means this adjustment can be applied to the center speaker only. (Example: When �FLAT� is selected.)
SEA
CNTR
100
1k
10k
To make the dialogue clearer, select �SHARP1� (little) or �SHARP2� (much). To make the dialogue softer, select �SOFT1� (little) or �SOFT2� (much). When �FLAT� is selected, no adjustment is applied. 8. Press EFFECT to select the effect level. Each time you press the button, the effect level changes as follows: DSP EFFECT 1 DSP EFFECT 2 DSP EFFECT 3
EFFECT
Note:
You cannot adjust the effect level when �REAR SPK� is set to �NONE� (see page 20).
7/P
DSP EFFECT 5
DSP EFFECT 4
As the number increases, the surround effect becomes stronger.
To cancel the Theater Surround mode Press SURROUND MODE repeatedly until �OFF� appears. The DSP and THEATER indicators goes off.