I PURHASED THIS PRODUCT BECAUSE I WAS HAVING PROBLEMS WITH MY CDR20 HARMAN KARDON RECORDER. WHICH I PURCHASED NEW 12 YEARS AGO. AFTER REVIEWING THE MANUAL, I WAS ABLE TO ADJUST THE TENSIONER IN THE SYSTEM. WORKS LIKE A CHAMP!.
SAVED ME AT LEAST 100.00 WHICH WAS WHAT A SERVICE REPAIR STATION WANTED. GREAT MANUAL EASY TO READ. SPECIALLY AFTER I PRINTED THE PAGES WHICH DEALT WITH MY RECORDER. THANKS A LOT!!!!!!!!
I have never bought a service manual which is as competely readable as this althogh it was a scanned pdf. Thank you for this succesful manual also cheaper than other sites.
Thanks for a very good and readable servicemanual. Just what I needed as a "dinosaur technician". I really recommmend this site and will come back.
Åsbjörn
The manual I purchased was just what I needed. I was glad to find a site where I can find so many manuals on a wide variety of products.
Text excerpt from page 13 (click to view)
RX-DP10VBK/RX-DP10VSL RX-DP10RSL
<Front panel assembly section>
Removing the FL display board & front AV in board (See Fig.1 and 2)
Prior to performing the following procedure, remove the top cover and the front panel assembly. 1. Pull out the volume knob on the front side of the front panel assembly and remove the nut attaching the FL display board. 2. Disconnect the harness from the connector CN973 on the front AV in board. 3. Remove the three screws A attaching the front AV in board. 4. Remove the nine screws B attaching the FL display board on the back of the front panel. 5. Disconnect the harnesses from connector CN969, CN975 and CN982 on the FL display board.
Operation switch panel
Nut Front panel assembly
Door Volume knob
Fig.1
Front AV in board FL display board CN969
CN975
Removing the power switch board & motor assembly (See Fig.3)
Prior to performing the following procedure, remove the front panel assembly and the FL display board. 1. Remove the four screws C attaching the power switch board. 2. Remove the three screws D attaching the motor assembly on the back of the front panel. 3. Remove the belt and the two screws a attaching the motor.
CN973
A
B
CN982
B C
Fig.2
Power switch board
E
Door
E
Belt
D
Removing the door input board (See Fig.3 and 4)
Prior to performing the following procedure, remove the front panel assembly and the FL display board. 1. Remove the four screws E attaching the door and remove the door from front panel assembly. Remove the six screws F attaching the door input 2. board. Fig.3