Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
Text excerpt from page 6 (click to view)
Connecting the Speakers
After connecting the front, center, rear speakers and/or a subwoofer, set the speaker setting information properly to obtain the best possible DSP effect. For details, see page 12. CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.
Speaker Layout Diagram
Connecting the front, center, and rear speakers
Right rear speaker
For each speaker, connect the (+) and (â) terminals on the rear panel to the (+) and (â) terminals marked on the speakers respectively.
1 Cut, twist and remove the insulation at the end of each speaker cord (not supplied). 2 Open the terminal, then insert the speaker cord. 3 Close the terminal.
Connecting the subwoofer
By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in the digital software.
Powered subwoofer (example)
Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs (not supplied). â¢ Refer also to the manual supplied for your subwoofer. Since bass sound is non-directional, you can place a subwoofer wherever you like. Normally place it in front of you.